Mount your SP-9100 in the factory upfitter position for your 2010-2014 (Gen1) Ford Raptor with our SDHQ Built mount. This mount was designed to securely fit the Switch Pros SP-9100 control panel inside the cab. This mount also includes the under the hood mounting plate and the necessary wires to securely mount your Switch Pros.
- No modifications of factory panel
- Designed for a tight fit with Switch Pros Bezel Mount Panels
- Included Reinforcement Backing Plate System
- Increases panel clip holding pressure
- Clamps switch panel into dash panel making it sturdy and theft resistant.
- Eliminates the chance of hardware vibrating loose
- NOTE: Switch Pros mounting in Factory upfitter location.
- Mounting plate mounts to firewall underneath the PCM.
- Retains factory hardware to mount the plate.
- Uses Switch Pros hardware to mount to mounting plate.
- Easy wire transfer due to location with any existing wiring.
- Simple and clean solution for mounting the Switch-Pro.
- (1) SDHQ laser cut face plate SDHQ-13-1130-G12-A
- (1) SDHQ laser cut Backing Reinforcement SDHQ-13-1130-G12-B
- (1)SDHQ Power Module Mount Plate SDHQ-13-1140-G12
- (1) SDHQ 36” 4GA Power Cable SDHQ-02-1140-36
- Optional Relay Pack Upgrade:
- Intended for use with high current applications.
- Incorporates two 35 amp relays and two 30 amp fuses.
- Sealed unit with all necessary connectors and seals.
- Mounts onto the Power Module Mounting Kit.
- Ability to add two 30 amp circuits on switches 1 through 7
- INSTALL INSTRUCTIONS